RTS “HS” Type Transfer Switch INTRODUCTION This manual has been prepared especially for the purpose of familiarizing personnel with the design, application, installation, operation and servicing of the applicable equipment. Read the manual carefully and comply with all instructions. This will help to. The automatic transfer switch is used for transferring critical electrical loads from a UTILITY (NORMAL) power source to an EMERGENCY (GENERATOR) power source. The transfer switch prevents electrical feedback between the UTILITY and EMERGENCY sources. For that reason, electrical codes require a transfer switch in all standby electric system. Generac transfer switches make it possible to switch between utility and generator power. Depending upon the application, the transfer switch will either work automatically or manually. Residential and Light Commercial Transfer Switches.
Automatic Transfer Switch Owner's Manual 3 Section 2 General Information — Introduction Thank you for purchasing a Gene rac transfer switch. This manual has been prepared especially for the purpose of familiarizing personnel with the design, application, installation, operation and servicing of the applicable equipment. This guide provides information on the general inspection, operation and maintenance procedures of manual and automatic transfer switches. Important: Before doing any work on the transfer switch, de-energize all sources of power. Workers should be properly qualified for the work being performed. A variety of automatic home standby transfer switches are available for use with Generac automatic home standby and commercial generators. They transfer power automatically to the generator source and switch back to utility power when it is restored.
Transfer Switches Clean Energy Owner Manual: MANUAL RTS /A /V: 0G EN: Install Manual: Generac Companies. Generac. Generac’s Pre-Wired Switch is an automatic transfer switch and distributed load center that backs up selected circuits for essential circuit coverage. Pre-wired for the easiest and least expensive installation on the market, they are an excellent value when whole house coverage is unnecessary. switch and the tungsten load does not exceed 30 percent of the switch rating. The automatic transfer switch is used for transferring critical electrical loads from a UTILITY (NORMAL) power source to an EMERGENCY (GENERATOR) power source. The transfer switch prevents electrical feedback between the UTILITY and EMERGENCY sources. For that reason, electrical codes require a transfer switch in all standby electric system.
0コメント